Notifications
Clear all
bryansp_ms
Group: Registered
Joined: 2019/03/14
Active Member
1
|
Multiple Platters..? In forum PrusaSlicer |
6 years ago | |
|
Thanks to everyone! I am printing out a Benchy now. Cleari... In forum Hardware, firmware and software help |
6 years ago | |
|
I have cleared the EPROM before while I was on a chat with s... In forum Hardware, firmware and software help |
6 years ago | |
|
Yes, I did try XYZ calibration right after power up before a... In forum Hardware, firmware and software help |
6 years ago | |
|
Yes, I did make sure of that. In forum Hardware, firmware and software help |
6 years ago | |
|
I appreciate the input. I did upgrade to the latest firmware... In forum Hardware, firmware and software help |
6 years ago | |
|
I was just illustrating that the PINDA sensor was detecting ... In forum Hardware, firmware and software help |
6 years ago | |
| I am having the same problem as well. Support has not been ... | 6 years ago | |
|
Cannot get past the initial XYZ calibration In forum Hardware, firmware and software help |
6 years ago |