|
I'm not sure, but I changed the firmware virsion that is dis... In forum Prusa i3 kit (Archive) |
9 years ago |
|
hi jack, I have done what you said above, with getting the ... In forum Improvements (Archive) |
9 years ago |
|
well I changed the board to the mega 2560, and got no red te... In forum Prusa i3 kit (Archive) |
9 years ago |
|
yes that is what I am doing, verify and compiling and upload... In forum Prusa i3 kit (Archive) |
9 years ago |
|
well, it dose actually say error. the text is just in red so... In forum Prusa i3 kit (Archive) |
9 years ago |
|
I think that is my problem, ive switch a few things around j... In forum Prusa i3 kit (Archive) |
9 years ago |
|
ok, thank you, I did everything and now have the latest Ardu... In forum Prusa i3 kit (Archive) |
9 years ago |
|
This report would have more information with
"Show verbose... In forum Prusa i3 kit (Archive) |
9 years ago |
|
when I downloaded that file, I cant find anything under the ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
thank you, ive downloaded that and uploaded, with out any ch... In forum Prusa i3 kit (Archive) |
9 years ago |
|
latest firmware In forum Prusa i3 kit (Archive) |
9 years ago |
|
same issue I had... it the 110v-220v switch on your PCU. its... In forum Prusa i3 kit (Archive) |
9 years ago |
|
you know far more then I do, it was hard to just follow all ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
did you ever get to the bottom of this? I am still on the fi... In forum Prusa i3 kit (Archive) |
9 years ago |
|
its working, just brought the bed up to 100* threw pronterfa... In forum Prusa i3 kit (Archive) |
9 years ago |
|
ok, back up and running now, turns out theres a fuse in the ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
awesome, I too am looking to do this, that is once I get the... In forum Software (Archive) |
9 years ago |
|
ok, I just tested the outputs with the switch set to 110 and... In forum Prusa i3 kit (Archive) |
9 years ago |
|
yes I know, thank you, I just ordered at 360w 30a, PSU. and ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
ok I swapped them around still 1.7-1.8, my leads are showing... In forum Prusa i3 kit (Archive) |
9 years ago |
