Prusa3D Forum

Notifications

Clear all

boz

Groupe: Enregistré

A(ont) rejoint: 2017/10/25

Active Member

	Adding to the list of thermistor problems Dans le forum Hardware, firmware and software help	il y a 7 years
	clean the bed with 90% rubbing alcohol then redo your live z... Dans le forum How do I print this? (Printing help)	il y a 7 years
	I got the V2 calibration gcode and ran that. It seemed like ... Dans le forum How do I print this? (Printing help)	il y a 7 years
	This is the first layer test results. At the beginning was s... Dans le forum How do I print this? (Printing help)	il y a 7 years
	I don't know what to make of it. This was working absolutely... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Also I didn't realize that this was just a steal plate and n... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Assembled Mk3 after a month suddenly prints a mess Dans le forum How do I print this? (Printing help)	il y a 7 years
	I cranked it up to 240 and I had to use an allen wrench that... Dans le forum Hardware, firmware and software help	il y a 7 years
	I tried preheating it the nozzle to 215 and then 220, but ne... Dans le forum Hardware, firmware and software help	il y a 7 years
	I've been shoving as hard as I can with filament to hope to ... Dans le forum Hardware, firmware and software help	il y a 7 years
	There are detailed guides to assembling a car but without th... Dans le forum Hardware, firmware and software help	il y a 7 years
	Third Print - ruined the teflon tube Dans le forum Hardware, firmware and software help	il y a 7 years
	Third Print - ruined the teflon tube Dans le forum Hardware, firmware and software help	il y a 7 years

Statistiques du forum

585 Forums

68.1 K Sujets

477.2 K Messages

13 En-ligne

75.8 K Membres

Le dernier des messages: Toolhead parked position Notre nouveau membre: Tommy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé