Prusa3D Forum

Notifications

Clear all

boris.p3

Group: Registered

Joined: 2018/08/23

Active Member

	Extruder wasn't set in the right position (there's the two l... In forum Assembly and first prints troubleshooting	6 years ago
	DISCLAIMER: This a MK3 with a Zaribo Kit. However, the extru... In forum Assembly and first prints troubleshooting	6 years ago
	When I am doing a Z calibration, I ran into the following th... In forum Assembly and first prints troubleshooting	6 years ago
	No, the cables are all right. After lots of tinkering last n... In forum Assembly and first prints troubleshooting	6 years ago
	Did you find a solution yet? I am pretty much running into t... In forum Assembly and first prints troubleshooting	6 years ago

Forum Statistics

565 Forums

63.9 K Topics

447.7 K Posts

19 Online

69.5 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed