Notifications
Clear all
Bomber
Group: Registered
Joined: 2016/11/12
Active Member
1
Live Z adjustments won't hold In forum Prusa i3 kit (Archive) |
8 years ago | |
Thanks for the suggestion. I was not doing that in prior po... In forum Software (Archive) |
8 years ago | |
Again, thank you so much for your patience! I am running th... In forum Software (Archive) |
8 years ago | |
Thanks for the replies! I am assuming that Octopi "just runs... In forum Software (Archive) |
8 years ago | |
I think that's where I'm confused.
If you installed from ... In forum Software (Archive) |
8 years ago | |
Thanks, Peter. I have made some adjustments to the octopi.tx... In forum Software (Archive) |
8 years ago | |
Hi guys.
Not sure where to go with this, so I thought I'd t... In forum Software (Archive) |
8 years ago |