|
Thanks for that, yes I'm going to contact Prusa when I get t... En el foro Hardware, firmware and software help |
hace 6 hours |
|
I'm not sure what happened there but I pasted the contents o... En el foro Hardware, firmware and software help |
hace 7 hours |
|
Hi, I finally got the input port error again, picture attach... En el foro Hardware, firmware and software help |
hace 10 hours |
|
Hi, Just an update, I just turned the Core One on and I got ... En el foro Hardware, firmware and software help |
hace 3 days |
|
I can only get a picture if and when it happens again, I wil... En el foro Hardware, firmware and software help |
hace 4 days |
|
Prusa core one input port overcurrent error En el foro Hardware, firmware and software help |
hace 4 days |
|
Yes, I have never had to input the type of filament before t... En el foro Hardware, firmware and software help |
hace 1 month |
|
Yes, that is a way of doing it but after this firmware updat... En el foro Hardware, firmware and software help |
hace 1 month |
|
Most of my prints are four or five colours and I sometimes o... En el foro Hardware, firmware and software help |
hace 1 month |
|
Thanks for replying, hopefully if enough people complain we ... En el foro Hardware, firmware and software help |
hace 1 month |
|
Firmware update 6.5.3 En el foro Hardware, firmware and software help |
hace 1 month |
|
No broken filament or debris triggering the sensor, did a fi... En el foro Hardware, firmware and software help |
hace 1 month |
|
Hi, thanks for your reply but as the print starts and comple... En el foro Hardware, firmware and software help |
hace 1 month |
|
Latest Firmware Update 6.5.3 Core One En el foro Hardware, firmware and software help |
hace 1 month |
|
MMU3 En el foro PrusaSlicer |
hace 4 months |
|
Hi, thanks for your reply and solution, something so simple ... En el foro PrusaSlicer |
hace 5 months |
|
Thanks for that, I will have a look at it in the morning and... En el foro PrusaSlicer |
hace 5 months |
|
I print it upside down as the top is the flat surface and th... En el foro PrusaSlicer |
hace 5 months |
|
Here is the file.
60966aef-putting-green-flag-65mm-1... En el foro PrusaSlicer |
hace 5 months |
|
Just an update, I tried your solution on a simple single col... En el foro PrusaSlicer |
hace 5 months |
