Prusa3D Forum

Notifications

Clear all

Bob D.

Groupe: Enregistré

A(ont) rejoint: 2022/02/14

Eminent Member

	I am using the smooth sheet that came with my MK3S+. Wheneve... Dans le forum How do I print this? (Printing help)	il y a 2 years
	This is at .20mm layer height and Z = -1.3. Bed was hot from... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I have not had time to work on this in the past week or so w... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thank you Joan for your examples. I will try setting the per... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I can't print the test text again right now as I have to get... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I will look into using other fonts. Changing the font is not... Dans le forum How do I print this? (Printing help)	il y a 2 years
	If this is a Z height problem, why are the voids visible in ... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Editing time limit on posts? This place is crazy. I go zip... Dans le forum How do I print this? (Printing help)	il y a 2 years
	the original file, yes, i can' share. but I have created a t... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I wanted to share the files for what I am going to run tests... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thanks for your input. I clean the bed before every print wi... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Yes it is my design. I created from scratch. That is not the... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I have been printing using the suggestions given to me in th... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thanks again to everyone for the help. I added the code that... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thanks for this thread, and to @Joan Tabb for her instructio... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Seems to be working for me based on my first test print. Now... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thanks everyone for taking the time to explain this and prov... Dans le forum How do I print this? (Printing help)	il y a 2 years
	That is the result I am looking for. Now I need to figure ho... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Print Infill Only In Secondary Color Dans le forum How do I print this? (Printing help)	il y a 2 years
	RE: Resume after scheduled pause does not heat the nozzle...... Dans le forum Hardware, firmware and software help	il y a 3 years

Page 1 / 2 Suivant

Statistiques du forum

559 Forums

62.9 K Sujets

443.1 K Messages

18 En-ligne

67.7 K Membres

Le dernier des messages: Purge Line settings difference between MK4 and Mini Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé