Prusa3D Forum

Notifications

Clear all

Bluxen

Skupina: Registrovaný

Přidal se: 2021/10/14

Active Member

	Oh, for real? I think that might be it. I started to clean m... In forum Assembly and first prints troubleshooting	před 4 years
	But it doesn't make sense, if it was under-extrusion every l... In forum Assembly and first prints troubleshooting	před 4 years
	The first layer is the only one with this problem, all the o... In forum Assembly and first prints troubleshooting	před 4 years
	xyzCalibration_cube Everything about the print is completely... In forum Assembly and first prints troubleshooting	před 4 years
	Fillamentum PLA, stock prusaslicer settings. The only layer ... In forum Assembly and first prints troubleshooting	před 4 years
	I mean sure but, this is pretty much what I explained. XYZ C... In forum Assembly and first prints troubleshooting	před 4 years
	Gaps in first layer In forum Assembly and first prints troubleshooting	před 4 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.9 K Příspěvky

10 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed