Notifications
Clear all
bluebrews
Group: Registered
Joined: 2017/02/23
Active Member
1
|
All,
I have printed some Nema17 vibration dampeners out of ... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Looking for something as well. I have greatly reduced mine ... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Good info. I ran into something similar last night. Wasn't... In forum Others (Archive) |
9 years ago | |
|
I've had luck almost completely eliminating the effect by pr... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Thanks for the reply.
Yep, I've tried in high power mode wi... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Thanks, had read through that one already but no solution.
... In forum Prusa i3 kit (Archive) |
9 years ago | |
| Great post! I'll be using this after my next print finishes... | 9 years ago | |
|
Advice on vertical artifact In forum Prusa i3 kit (Archive) |
9 years ago |