Prusa3D Forum

Notifications

Clear all

bloblob

Group: Registered

Joined: 2018/07/22

Active Member

	That disassembly procedure was greatly helpful. My last atte... In forum Assembly and first prints troubleshooting	4 years ago
	@fovea1959-prusa Thanks for the heads up about that thread -... In forum Assembly and first prints troubleshooting	4 years ago
	MK3S upgrade filament sensor not working In forum Assembly and first prints troubleshooting	4 years ago
	And now that I've tried to offer advice, I can't get any pri... In forum Assembly and first prints troubleshooting	6 years ago
	I was having this same problem off and of this week. I'm in ... In forum Assembly and first prints troubleshooting	6 years ago
	FYI I just tested this, and then also tested putting the bed... In forum Assembly and first prints troubleshooting	6 years ago
	Lots of people probably know all this already, but I just wa... In forum Assembly and first prints troubleshooting	6 years ago
	I've only had my printer for about a week, but when I've sta... In forum Assembly and first prints troubleshooting	6 years ago
	Strange artifact on one side of 3d printed cylinder In forum Assembly and first prints troubleshooting	6 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.8 K Posts

21 Online

67.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed