Notifications
Clear all
BillR94
Group: Registered
Joined: 2021/09/03
Trusted Member
3
| Yes, I have it connected to the micro USB 2.0 (for periphera... | 1 year ago | |
| Can't get the webcam to work with Octoprint. | 1 year ago | |
|
After extruder jam. Prints won't stick to the bed. Help! In forum Hardware, firmware and software help |
2 years ago | |
|
Thank you so much for the help. In forum Hardware, firmware and software help |
3 years ago | |
|
it says I attached it but I don't see it here. In forum Hardware, firmware and software help |
3 years ago | |
|
Of course. Here you go. This was done in S3D. I downloaded t... In forum Hardware, firmware and software help |
3 years ago | |
|
So, if I understand you correctly, if I comment out or dele... In forum Hardware, firmware and software help |
3 years ago | |
|
thank you Joan. I'm not the greatest with G-code so please e... In forum Hardware, firmware and software help |
3 years ago | |
|
Start Ggode for S3d In forum Hardware, firmware and software help |
3 years ago |
Page 3 / 3
Prev