Bill – Activité – Prusa3D Forum

Notifications

Clear all

Bill

Groupe: Enregistré

A(ont) rejoint: 2017/03/07

Estimable Member

	Disable print fan error RPM sensor? Dans le forum Others (Archive)	il y a 7 years
	Maybe an automatic popup of the Preheat menu? Yep, that wo... Dans le forum Others (Archive)	il y a 7 years
	I have about 10 socks on hand and have used them since I had... Dans le forum Others (Archive)	il y a 7 years
	Filament Sensor still unreliable Dans le forum Others (Archive)	il y a 7 years
	Support has to provide you authorized access to this portion... Dans le forum Others (Archive)	il y a 7 years
	No uso cura así que no puedo ofrecer ninguna ayuda allí. Per... Dans le forum Others (Archive)	il y a 7 years
	I do not speak or read German, but from what I could read of... Dans le forum Others (Archive)	il y a 7 years
	Those overhangs do not look severe enough to need support bu... Dans le forum Others (Archive)	il y a 7 years
	Hi Ryan, I understand that Prusa use Simplify 3d for sl... Dans le forum Others (Archive)	il y a 7 years
	Hi, You mean all these? extruder-body extruder-cover extrud... Dans le forum Others (Archive)	il y a 7 years
	For me, nozzles. Cheap Chinese ones on ebay or aliexpress a... Dans le forum Others (Archive)	il y a 7 years
	You might try downgrading your firmware to RC4. Quite a few... Dans le forum Others (Archive)	il y a 7 years
	I got lazy and did not downgrade the firmware like I said in... Dans le forum Others (Archive)	il y a 7 years
	Welp, Count me in on the drooping fan shield/cooling duct. ... Dans le forum Others (Archive)	il y a 7 years
	I have access to the Prusa parts store, but I could not find... Dans le forum Others (Archive)	il y a 7 years
	Im also going into this eyes wide open, even though this is ... Dans le forum Others (Archive)	il y a 7 years
	Sounds like the idler pulley is rubbing against the housing ... Dans le forum Others (Archive)	il y a 7 years
	Just want to add that changing the smooth idler for a toothe... Dans le forum How do I print this? (Printing help)	il y a 7 years
	Did you build this? Buy this? Available anywhere? I just b... Dans le forum Others (Archive)	il y a 7 years
	Well, I had another layer shift today. I have a part for my... Dans le forum Others (Archive)	il y a 7 years

Page 4 / 11 Précédent Suivant

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

24 En-ligne

68.1 K Membres

Le dernier des messages: Filament stuck in nextruder Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé