Activité
 
Notifications
Clear all
BernieC
BernieC
Groupe: Enregistré
A(ont) rejoint: 2018/09/01
Trusted Member
3
Thanks for the explanation. I have your print settings sav...

Dans le forum Hardware, firmware and software help

il y a 5 years
I'm a little baffled. I don't see where all the fanciness ...

Dans le forum Hardware, firmware and software help

il y a 5 years
WOW -- thanks!!! I got the model to print and the support...

Dans le forum Hardware, firmware and software help

il y a 5 years
@neophyl Thanks for the info. I'm inclined to wait for Ti...

Dans le forum Hardware, firmware and software help

il y a 5 years
I"m still stuck. First a simple question: if I load my 'sta...

Dans le forum Hardware, firmware and software help

il y a 5 years
I imported the project and "sliced" it and it doesn't print...

Dans le forum Hardware, firmware and software help

il y a 5 years
Thanks again for the help -- but.. I tried printing the proj...

Dans le forum Hardware, firmware and software help

il y a 5 years
Thanks again for the help -- but.. I tried printing the proj...

Dans le forum Hardware, firmware and software help

il y a 5 years
@tim-m30 Wow -- thanks for all the help! I don't understand...

Dans le forum Hardware, firmware and software help

il y a 5 years
Thanks for all the help. The reason for all the strangenes...

Dans le forum Hardware, firmware and software help

il y a 5 years
OK, I know it is hard to see. In the attached picture, the ...

Dans le forum Hardware, firmware and software help

il y a 5 years
Look at the pyramids. All three of the 'bottom' pyramids [...

Dans le forum Hardware, firmware and software help

il y a 5 years
My apologies -- I've done so much futzing and re-prints of t...

Dans le forum Hardware, firmware and software help

il y a 5 years
supports on a slanted surface

Dans le forum Hardware, firmware and software help

il y a 5 years
I did and I'm amazed -- it was easy!! I saw the 'modifiers...

Dans le forum Hardware, firmware and software help

il y a 5 years
That's custom supports -- as I mentioned, I'm OK with them. ...

Dans le forum Hardware, firmware and software help

il y a 5 years
@tim-m30 Is there a tutorial or something explaining that? ...

Dans le forum Hardware, firmware and software help

il y a 5 years
support is too strong

Dans le forum Hardware, firmware and software help

il y a 5 years
.. and here is what it looks like after about 2 hrs of picki...

Dans le forum General discussion, announcements and releases

il y a 5 years
I realize nobody really cares, but the dental picks worked a...

Dans le forum General discussion, announcements and releases

il y a 5 years
Page 3 / 5
Partager :