Ben – Activité – Prusa3D Forum

Notifications

Clear all

Ben

Groupe: Enregistré

A(ont) rejoint: 2016/06/22

Reputable Member

	To be completely honest he is not the first to have crap ser... Dans le forum Others (Archive)	il y a 8 years
	To update I have now received my heat bed so a big thank you... Dans le forum Others (Archive)	il y a 8 years
	Have I in anyway said I want a heat bed on warranty? Nope, s... Dans le forum Others (Archive)	il y a 8 years
	Hi thank you. From my first email I wanted a new bed. I kno... Dans le forum Others (Archive)	il y a 8 years
	Thanks. I will. 😉 That is not my problem that Prusa are ... Dans le forum Others (Archive)	il y a 8 years
	I think I have no choice but to contact my credit card compa... Dans le forum Others (Archive)	il y a 8 years
	Ok thanks. Definitely penetrated that and damaged the board ... Dans le forum Others (Archive)	il y a 8 years
	How thick is the PEI sheet? Dans le forum Others (Archive)	il y a 8 years
	Hi and thanks everyone for your replied it is much appreciat... Dans le forum Others (Archive)	il y a 8 years
	Thats a cool ( 😳 ) idea. Will hopefully help loads with... Dans le forum Improvements (Archive)	il y a 8 years
	Yes its £7 for the sheet. £18 postage 😆 Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Complaining? Dans le forum Others (Archive)	il y a 8 years
	Bed always on Dans le forum Others (Archive)	il y a 8 years
	does this have to be done via pc or can it be done via sd? (... Dans le forum Others (Archive)	il y a 8 years
	I would say go back to the shipped firmware and try again if... Dans le forum Others (Archive)	il y a 8 years
	Aha. Thank you 😆 Ok I will leave it with what came wi... Dans le forum Others (Archive)	il y a 8 years
	Thanks. A good point on the forum and public knowing more th... Dans le forum Others (Archive)	il y a 8 years
	Its not your fault the P.I.N.D.A decided to hit the deck. It... Dans le forum Others (Archive)	il y a 8 years
	Missing layers and extruder motor not pulling in filament Dans le forum Others (Archive)	il y a 8 years
	Yes all calibrated so either P.I.N.D.A is allowing and not s... Dans le forum General discussion, announcements and releases	il y a 8 years

Page 15 / 16 Précédent Suivant

Statistiques du forum

565 Forums

63.9 K Sujets

447.7 K Messages

22 En-ligne

69.5 K Membres

Le dernier des messages: Filament wechsel in einem Layer Notre nouveau membre: Mechman0124 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé