Notifications
Clear all
Bascule
Bascule
Group: Registered
Joined: 2021/03/25
Eminent Member
2
Cheers, so I'm guessing this print should be fine to see an ...

In forum How do I print this? (Printing help)

4 years ago
My guess is that maybe you have the Bondtech gears too tight...

In forum How do I print this? (Printing help)

4 years ago
How transparent/translucent is Flexfill Natural?

In forum How do I print this? (Printing help)

4 years ago
Thank you kindly!

In forum Hardware, firmware and software help

4 years ago
I'm not sure whether there is anything wrong with your print...

In forum Hardware, firmware and software help

4 years ago
Sign printing/designing software

In forum Hardware, firmware and software help

4 years ago
Yup, that coupling the printer to the heavy slab, and decoup...

In forum Hardware, firmware and software help

4 years ago
@towlerg No, the printer is coupled to the marble slab/paver...

In forum Hardware, firmware and software help

4 years ago
And here it is. OMG that has made a MASSIVE difference to th...

In forum Hardware, firmware and software help

4 years ago
@bobstro Yeah, that's nice. 🙂 My design is to have two marb...

In forum Hardware, firmware and software help

4 years ago
Oh, ignore me. I managed to find the right keywords and foun...

In forum Hardware, firmware and software help

4 years ago
Heavy glass/granite slab for printer?

In forum Hardware, firmware and software help

4 years ago
@tim-2 Thanks! I've not had much in the way of adhesion issu...

In forum General discussion, announcements and releases

4 years ago
OK, some improvement and I have an at least functional print...

In forum How do I print this? (Printing help)

4 years ago
@Swiss_Cheese, pretty please with a cherry on top if you'd b...

In forum How do I print this? (Printing help)

4 years ago
That's a good question - I didn't question why these were pr...

In forum How do I print this? (Printing help)

4 years ago
PrusaSlicer not generating supports?

In forum Hardware, firmware and software help

4 years ago
Thanks!! I'll try your suggestions. Yes, I had set to 15mm/s...

In forum Hardware, firmware and software help

4 years ago
Filament jams on retract above Bondtech gear?

In forum Hardware, firmware and software help

4 years ago
Fillamentum Flexfill printing problem

In forum How do I print this? (Printing help)

4 years ago
Page 1 / 2
Share: