Notifications
Clear all
B3DWorks
Group: Registered
Joined: 2018/02/08
Active Member
1
| Hot idea- printing overhangs without supports | 5 years ago | |
|
Well. I have found the culprit! Underneath the textured shee... In forum Print tips (Archive) |
6 years ago | |
|
Calibration with 0.60mm nozzle In forum Print tips (Archive) |
6 years ago | |
| I did that and I still have the usual settings. 0.60 is not ... | 6 years ago | |
| @bobstro I do not see Configuration assistant- only Configu... | 6 years ago | |
| 0.60mm hotend tip profile missing | 6 years ago | |
|
Watchful eye on your 3d prints with AI In forum General software discussion |
6 years ago | |
| Eliminate FDM stair stepping- study | 6 years ago | |
| I heard back from E3D: "The thermal paste we use and recomm... | 7 years ago | |
| I think I will have to take this question to E3D | 7 years ago | |
| Thermal paste for Heatbreak | 7 years ago | |
|
That is a good idea. Not a problem with a little bracing. I ... In forum Others (Archive) |
8 years ago | |
|
Enclosure- supply and controller location In forum Others (Archive) |
8 years ago |