Benachrichtigungen
Alles löschen
armer_geddon
armer_geddon
Gruppe: Registriert
Beigetreten: 2019/11/01
Eminent Member
2
@incendium87 During the lockdown I finally got around to dis...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
The dimensions of the cuboid mentioned in the first post sho...

Im Forum How do I print this? (Printing help)

Vor 5 years
@robert-rmm200 Sorry, the picture was not that great. It is ...

Im Forum How do I print this? (Printing help)

Vor 5 years
Fringed edge in Slicer (Lithophane)

Im Forum How do I print this? (Printing help)

Vor 5 years
Na das hört sich doch nach einem sinnvollen Feature und deut...

Im Forum Hilfe zur Hardware, Firmware und Software

Vor 5 years
@robert-rmm200 Generally I would agree, that something that ...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
Unabhängig von den oben geschilderten Lösungsansätzen denke ...

Im Forum Hilfe zur Hardware, Firmware und Software

Vor 5 years
Hallo nicoeisold, soweit ich weiß ist das bisher so nicht di...

Im Forum Hilfe zur Hardware, Firmware und Software

Vor 5 years
@incendium87 It is the same for me. I tried shaving away a s...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
@bodo: thanks for the translation, but I got that since Germ...

Im Forum General discussion, announcements and releases

Vor 5 years
@karl-herbert: but this means, I can keep extending my licen...

Im Forum General discussion, announcements and releases

Vor 5 years
You cannot really see it in a photo, as it goes directly bel...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
I guess it is pretty expensive, but for now I have free acce...

Im Forum General discussion, announcements and releases

Vor 5 years
I also use Solidworks, it is what I use for my university as...

Im Forum General discussion, announcements and releases

Vor 5 years
Well, I already did some research on 3D printing, but obviou...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
I already did clean the bed multiple times with hot water an...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
Hi, Thanks for the quick reply! I did already switch to 7x7 ...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
PLA Adhesion, wider Extrusion not overlapping and regular cu...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
I received my Kit just this Week and put it together yesterd...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
I also had a similar problem and came up with this 0.5 mm sp...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
Seite 1 / 2
Teilen: