Notifications
Clear all
Arios
Group: Registered
Joined: 2019/03/11
Active Member
1
|
Actually that did work! No more M73 Error! In forum PrusaSlicer |
5 years ago | |
|
Why are there two locations for retraction settings? In forum PrusaSlicer |
5 years ago | |
|
I disabled that earlier thinking it would get rid of that er... In forum PrusaSlicer |
5 years ago | |
|
Is there a way to disable the M73 command? In forum PrusaSlicer |
5 years ago | |
|
It prints amazingly well. .2 layer height on both prints. In forum PrusaSlicer |
5 years ago | |
|
It prints!!!!... but I keep getting an error on the console:... In forum PrusaSlicer |
5 years ago | |
|
Testing that now. I was able to copy start and end g codes. In forum PrusaSlicer |
5 years ago | |
|
Prusaslicer Profile for the Troodon 400x400x500 In forum PrusaSlicer |
5 years ago |