Prusa3D Forum

Notifications

Clear all

Archania

Groupe: Enregistré

A(ont) rejoint: 2015/11/24

Trusted Member

	Separation of Layers - tried a bunch and lost Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Yes you can continue printing just if you have any prints ov... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Nope. My printers have their own little room. Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Yup. Have 11.?? volts coming from the power supply. So that'... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Right now no voltage is going to the bed if it is plugged in... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Bed has stopped heating again Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Ok. Will get everything back together and try it out. See wh... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Burned out RAMBo? Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I would also purchase another one. Since getting mine in Dec... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I have another little issue that bugs me to no end. I have t... Dans le forum Improvements (Archive)	il y a 9 years
	Hi Scott, did you replace the Firmware by the version dedica... Dans le forum Improvements (Archive)	il y a 9 years
	Hmm that i didn't do yet. I do have version 2.2.4 but that i... Dans le forum Improvements (Archive)	il y a 9 years
	Replace the E3D v6 Lite with a full E3D v6.... Dans le forum Improvements (Archive)	il y a 9 years
	Just an update. I was finally able to get around to replacin... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	If i measured correctly with the machine off and between the... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I will just pick up a new v6 lite hotend. They are cheap eno... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	NOOOO it is purple!!! purple i say PURPLE! lol Might have t... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Well I did that.. all seemed good. I ran a program.. all see... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Lol that is my son.. he though purple would be cool... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I am trying to lower the fan speed.. see if that will make a... Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Page 1 / 5 Suivant

Statistiques du forum

559 Forums

63 K Sujets

443.7 K Messages

21 En-ligne

67.9 K Membres

Le dernier des messages: Can't Correctly Adjust PINDA Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé