Notifications
Clear all
Archania
Archania
Group: Registered
Joined: 2015/11/24
Trusted Member
3
Separation of Layers - tried a bunch and lost

In forum Prusa i3 kit (Archive)

8 years ago
Yes you can continue printing just if you have any prints ov...

In forum Prusa i3 kit (Archive)

9 years ago
Nope. My printers have their own little room.

In forum Prusa i3 kit (Archive)

9 years ago
Yup. Have 11.?? volts coming from the power supply. So that'...

In forum Prusa i3 kit (Archive)

9 years ago
Right now no voltage is going to the bed if it is plugged in...

In forum Prusa i3 kit (Archive)

9 years ago
Bed has stopped heating again

In forum Prusa i3 kit (Archive)

9 years ago
Ok. Will get everything back together and try it out. See wh...

In forum Prusa i3 kit (Archive)

9 years ago
Burned out RAMBo?

In forum Prusa i3 kit (Archive)

9 years ago
I would also purchase another one. Since getting mine in Dec...

In forum Prusa i3 kit (Archive)

9 years ago
I have another little issue that bugs me to no end. I have t...

In forum Improvements (Archive)

9 years ago
Hi Scott, did you replace the Firmware by the version dedica...

In forum Improvements (Archive)

9 years ago
Hmm that i didn't do yet. I do have version 2.2.4 but that i...

In forum Improvements (Archive)

9 years ago
Replace the E3D v6 Lite with a full E3D v6....

In forum Improvements (Archive)

9 years ago
Just an update. I was finally able to get around to replacin...

In forum Prusa i3 kit (Archive)

9 years ago
If i measured correctly with the machine off and between the...

In forum Prusa i3 kit (Archive)

10 years ago
I will just pick up a new v6 lite hotend. They are cheap eno...

In forum Prusa i3 kit (Archive)

10 years ago
NOOOO it is purple!!! purple i say PURPLE! lol Might have t...

In forum Prusa i3 kit (Archive)

10 years ago
Well I did that.. all seemed good. I ran a program.. all see...

In forum Prusa i3 kit (Archive)

10 years ago
Lol that is my son.. he though purple would be cool...

In forum Prusa i3 kit (Archive)

10 years ago
I am trying to lower the fan speed.. see if that will make a...

In forum Prusa i3 kit (Archive)

10 years ago
Page 1 / 5
Share: