|
Hmmmm. That was the first thing i checked and and all three ... In forum Hardware, firmware and software help |
2 months ago |
|
And to clarify, this problem was found when doing a self tes... In forum Hardware, firmware and software help |
2 months ago |
|
Yes, when pre-heating, there's zero voltage at the lugs on t... In forum Hardware, firmware and software help |
2 months ago |
|
Thanks for the reply. The LED isn't lit. There's no voltag... In forum Hardware, firmware and software help |
2 months ago |
|
Bed Not Heating In forum Hardware, firmware and software help |
2 months ago |
|
@txroadracer I think I may have found my issue and since you... In forum Hardware, firmware and software help |
9 months ago |
|
Very possible. I chatted with Prusa customer support about... In forum Hardware, firmware and software help |
9 months ago |
|
I still can't figure this out. Crashing on the X axis. One... In forum Hardware, firmware and software help |
9 months ago |
|
I did a belt test with X at 210 and Y at 270. Decided to re... In forum Hardware, firmware and software help |
10 months ago |
|
Just to add... I had about 20 or so good prints with no hard... In forum Hardware, firmware and software help |
10 months ago |
|
Interesting Issue...Crashing After 5-10 Layers Printed. In forum Hardware, firmware and software help |
10 months ago |
|
No worries! Appreciate the input! Glad to get it sorted ou... In forum Hardware, firmware and software help |
11 months ago |
|
Thanks again for suggesting the magnets. They were good, b... In forum Hardware, firmware and software help |
11 months ago |
|
Thanks for the reply. I didn't touch the magnets so I didn'... In forum Hardware, firmware and software help |
11 months ago |
|
Well, still having issues with this. It's continuing to pri... In forum Hardware, firmware and software help |
11 months ago |
|
It seems to be installed correctly. Maybe I bumped the wire... In forum Hardware, firmware and software help |
12 months ago |
|
Appreciate the reply. Excuse my ignorance...which sensor? ... In forum Hardware, firmware and software help |
12 months ago |
|
Replaced The Hot End, Now Having Loading Issues. In forum Hardware, firmware and software help |
12 months ago |
|
Nope, just randomly. Seems like it's doing it every couple ... In forum General discussion, announcements and releases |
1 year ago |
|
What Causes This? In forum General discussion, announcements and releases |
1 year ago |
