Notifications
Clear all
aowilkie
aowilkie
Skupina: Registrovaný
Přidal se: 2018/01/15
Eminent Member
2
What are these lines?

In forum Assembly and first prints troubleshooting

před 5 years
@neophyl Thanks for the help! I'll try and go through what y...

In forum How do I print this? (Printing help)

před 5 years
@neophyl Any idea how I can go about fixing it? It's a swit...

In forum How do I print this? (Printing help)

před 5 years
bump

In forum How do I print this? (Printing help)

před 5 years
Thanks for the tip! Reuploaded the file here! Attachment r...

In forum How do I print this? (Printing help)

před 5 years
Prusa Slicer fills in hole in my model? Tried repairing, and...

In forum How do I print this? (Printing help)

před 5 years
Problems printing on supports

In forum Assembly and first prints troubleshooting

před 6 years
Cost to rent a printer?

In forum General discussion, announcements and releases

před 6 years
Tried printing again with same print settings but slowed eve...

In forum Assembly and first prints troubleshooting

před 7 years
Also noticing that the layers only seem to shift on the Y ax...

In forum Assembly and first prints troubleshooting

před 7 years
Shifting layers randomly and stringing

In forum Assembly and first prints troubleshooting

před 7 years
I had an intermittent wire in my PINDA cable. Watch the red...

In forum Others (Archive)

před 7 years
Just checked the board and it is plugged in correctly, re-ad...

In forum Others (Archive)

před 7 years
Hi Alex, Have you ever sorted out your issue? I have the e...

In forum Others (Archive)

před 7 years
PINDA Cable broken?

In forum Others (Archive)

před 7 years
I tried repairing the file is Slic3r as suggested above but ...

In forum Print tips (Archive)

před 7 years
Sorry for repeat posts but can anyone help me with the setti...

In forum Print tips (Archive)

před 7 years
Sorry to ask for calirification but could you run me through...

In forum Print tips (Archive)

před 7 years
Thanks for the response! Still new to 3D printing so this i...

In forum Print tips (Archive)

před 7 years
Prusa Control places supports through model file?

In forum Print tips (Archive)

před 7 years
Stránka 1 / 2
Share: