|
Hi Tim,
Couple things I found with my 3mm version before I ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
I found it easiest to just drill out the center of the suppl... In forum Improvements (Archive) |
9 years ago |
|
Robert,
I have tried a few things, what if found to be the ... In forum Improvements (Archive) |
9 years ago |
|
Hey Peter,
Thanks for the file, I will certainly have a loo... In forum Software (Archive) |
9 years ago |
|
Josef,
Thanks for the reply, would be great to get the file... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Chaps,
Sorry for the late reply on this one, been busy at w... In forum Software (Archive) |
9 years ago |
|
Hey Peter,
Good to hear that it reflashed for you. I agree ... In forum Software (Archive) |
9 years ago |
|
Michal,
Thanks for finally touching base on this, it is gre... In forum Software (Archive) |
9 years ago |
|
Hey Roman,
Thanks for the links, will have a look. I am in ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Hey Peter,
The mod was simple, I used the following process... In forum Software (Archive) |
9 years ago |
|
Thanks peter,
I have tried multiple speeds and doesn't make... In forum Software (Archive) |
9 years ago |
|
Hey Roman,
thanks for the note, i will contact PR about it ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
1.75mm Version Duct fan scad file In forum Prusa i3 kit (Archive) |
9 years ago |
|
Hey David,
I had the same problem, the issue is to do with ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Thanks for the reply again,
I have checked a few things,
"... In forum Software (Archive) |
9 years ago |
|
Hey Guys,
Thanks for the feedback. I certainly don't want t... In forum Software (Archive) |
9 years ago |
|
Hey guys,
Further to this, i reconfigured the fan such that... In forum Software (Archive) |
9 years ago |
|
PLA Cooling fan drops nozzle temp below EXTRUDE_MINTEMP valu... In forum Software (Archive) |
9 years ago |
|
Thanks for the reply.
That doesn't make sense to me so modi... In forum Software (Archive) |
9 years ago |
|
sometimes you can't stop the delamination, one of the issues... In forum Print tips (Archive) |
9 years ago |
