Prusa3D Forum

Notifications

Clear all

AndyE

Group: Registered

Joined: 2020/12/10

Active Member

	I'm considering adding a wifi chip to my Mini, so I read thr... In forum Hardware, firmware and software help	3 years ago
	I'm still digging on this one. Chatted with Prusa online yes... In forum PrusaSlicer	3 years ago
	Consistent perimeter direction? In forum PrusaSlicer	3 years ago
	I ran across this thread while looking for ways I might impr... In forum General discussion, announcements and releases	4 years ago
	@cwbullet Still too close, or not close enough? Compared to ... In forum How do I print this? (Printing help)	4 years ago
	After reading and looking at more photos, I backed off on th... In forum How do I print this? (Printing help)	4 years ago
	"Rough" first layer after several near-perfect ones In forum How do I print this? (Printing help)	4 years ago
	Another PETG newb In forum How do I print this? (Printing help)	5 years ago
	Any updates on this? Still in progress, estimated availabili... In forum General discussion, announcements and releases	5 years ago
	@raymate In forum Assembly and first prints troubleshooting	5 years ago
	@raymate They said the lube that came with the printer. You ... In forum Assembly and first prints troubleshooting	5 years ago
	@zemb Mine has been doing it since the very first print. Pru... In forum Assembly and first prints troubleshooting	5 years ago
	What about in the USA? I know there’s always Amazon, but wha... In forum General discussion, announcements and releases	5 years ago

Forum Statistics

585 Forums

68.2 K Topics

477.5 K Posts

12 Online

75.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed