Activity
 
Notifications
Clear all
Andybx
Andybx
Group: Registered
Joined: 2019/04/10
Eminent Member
2
Milo- Do you have a link for the heatbreak you ordered. I lo...

In forum Hardware, firmware and software help

5 years ago
Thanks for the heads up I was about to cut it down....saved ...

In forum Hardware, firmware and software help

5 years ago
Yeah I'm going to make a c clip to hold the ptfe tube in pla...

In forum Hardware, firmware and software help

5 years ago
Forgot to add and not sure if this has anything to do with j...

In forum Hardware, firmware and software help

5 years ago
It cant hurt to try as I have a spare hotend assembly as the...

In forum Hardware, firmware and software help

5 years ago
I know i was asked if it was one or two x bearings that fail...

In forum Hardware, firmware and software help

5 years ago
Thanks I think I might order one and try it out. Can you use...

In forum Hardware, firmware and software help

5 years ago
Thanks I read something about that earlier moving to an E3D ...

In forum Hardware, firmware and software help

5 years ago
Update it's not in an enclosure just open on the desk with s...

In forum Hardware, firmware and software help

5 years ago
Jams Attachment removed

In forum Hardware, firmware and software help

5 years ago
Filament removed from jams Attachment removed

In forum Hardware, firmware and software help

5 years ago
I'd not thought of that....I'm Printing in the spare room bu...

In forum Hardware, firmware and software help

5 years ago
Sorry I should have added that earlier. It's PLA Eryone fila...

In forum Hardware, firmware and software help

5 years ago
Printer Jams

In forum Hardware, firmware and software help

5 years ago
I have the same on a 4 month old printer - Contacted Prusa l...

In forum Hardware, firmware and software help

5 years ago
Thanks again!! Still not perfect but you can see a slight ho...

In forum Assembly and first prints troubleshooting

6 years ago
Thanks for the advice I tighten the screw and printed the be...

In forum Assembly and first prints troubleshooting

6 years ago
Thanks I appreciate that. I'll give it a go when I get home ...

In forum Assembly and first prints troubleshooting

6 years ago
I'm getting a similar issue with a new build and test gear m...

In forum Assembly and first prints troubleshooting

6 years ago
Sounds like it could but you nozzel Z height if your lines a...

In forum Assembly and first prints troubleshooting

6 years ago
Page 1 / 2
Share: