|
This is probably not worth the effort, but assuming you sti... In forum Hardware, firmware and software help |
4 years ago |
|
Thanks for the in depth response, My hotend also had the rot... In forum Hardware, firmware and software help |
4 years ago |
|
Out of curiosity, does your heater block wiggle from side to... In forum Hardware, firmware and software help |
4 years ago |
|
Thanks for the reply. My problem is pretty similar and I sti... In forum Hardware, firmware and software help |
4 years ago |
|
Nozzle and Heat break stuck in heater block In forum Hardware, firmware and software help |
4 years ago |
|
Filament not feeding but no jam is present In forum Hardware, firmware and software help |
5 years ago |
|
To clarify, the pictures of the jams I posted were of the or... In forum Hardware, firmware and software help |
5 years ago |
|
I’ve already replaced the heartbreak with a stock e3d heartb... In forum Hardware, firmware and software help |
5 years ago |
|
Sorry for the long wait its been crazy busy, I have not yet ... In forum Hardware, firmware and software help |
5 years ago |
|
No insult taken, I understand the need to check all possibil... In forum Hardware, firmware and software help |
5 years ago |
|
Thank you for the advice. I did some quick tests based off o... In forum Hardware, firmware and software help |
5 years ago |
|
How high is your retraction settings? In forum Hardware, firmware and software help |
5 years ago |
|
Yes I did replace the PTFE tube In forum Hardware, firmware and software help |
5 years ago |
|
My printer has identical issues (Documented here) that have ... In forum Hardware, firmware and software help |
5 years ago |
|
MK3s Constant Jams/Layer Skips Almost 100% fail rate In forum Hardware, firmware and software help |
5 years ago |
