Allen8355 – Activité – Prusa3D Forum

Notifications

Clear all

Allen8355

Groupe: Enregistré

A(ont) rejoint: 2017/01/25

Estimable Member

	I think it comes down to will I use it enough to migrate the... Dans le forum Others (Archive)	il y a 7 years
	I ordered and received the MMU but luckily I never installed... Dans le forum Others (Archive)	il y a 7 years
	Just wait and use what you have for a while. Many of the 2.... Dans le forum Others (Archive)	il y a 7 years
	I wasn't very impressed with that article. It seems like th... Dans le forum Others (Archive)	il y a 7 years
	I use it on a different printer and it works really nice. Ev... Dans le forum Improvements (Archive)	il y a 7 years
	What firmware are you using? i had that problem with 3.0.10 ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	I have always had the ever increasing Z adjust problem. "I... Dans le forum Others (Archive)	il y a 7 years
	For me, 3.0.11 seems to have fixed my ever increasing Z leve... Dans le forum Others (Archive)	il y a 8 years
	I personally would be very very careful with acetone. Maybe ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	There are some tricks here. On adjusting the PINDA, the set... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Could anyone suggest the download location for the firmware ... Dans le forum Others (Archive)	il y a 8 years
	I have the thicker PEI as well, and it is possible to find a... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I have to calibrate almost every time because I have constan... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	on the MK2, try maybe 2mm retraction. Only increase retract... Dans le forum Others (Archive)	il y a 8 years
	I feel your pain. I have problems as well. What bed tempera... Dans le forum Others (Archive)	il y a 8 years
	For me, and I experimented a bunch, the stringing was caused... Dans le forum Others (Archive)	il y a 8 years
	I agree entirely that this is a problem that needs to be sol... Dans le forum Others (Archive)	il y a 8 years
	I did not change the Z-live adjustment for the salt. I'm cu... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	The Salt Solution for PLA Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	While I know its a matter of preference, I will also add not... Dans le forum Hardware, firmware and software help	il y a 8 years

Page 9 / 10 Précédent Suivant

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

22 En-ligne

68.1 K Membres

Le dernier des messages: Upgrade wishes Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé