Activity
 
Notifications
Clear all
Albe
Albe
Group: Registered
Joined: 2017/08/03
Eminent Member
2
I have been out of the loop the last 8 months or so... Can s...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Any luck on this?

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Guys I know it has been said a lot but don't look past the b...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Did a factory reset - clear all. Ran the wizard, XYZ calibra...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Sorry not sure I follow you - what changes are you referring...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
I don't know if it is just me - the latest firmware (today) ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
I asked on the commit if it was permanent - mkbel replied no...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
@guy-k2 I think I'm very close to where I want to be. I do ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Wouldn't it just be easier to go for a E3D Volcano and 0.6 n...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Correct

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Exact same issue I had - RESET to factory defaults solved th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
For now you can just change #define Z_MAX_POS 210 to #defin...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Update - It worked!! I'll remember this now - anything weird...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Had to put kids to bed first. Looks you you hit the nail on ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
OK will do that. Will let you know what happens

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Motors are 17HM15-0904S. Y distance with the blocker at t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Swopped the settings to switch the settings one by one betwe...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
OK I'm completely out of ideas with the OMC motors. Using t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Yup using rpi heatsinks

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Good luck, sounds like a lot of work. Just some clarity on t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Page 1 / 3
Share: