Prusa3D Forum

Notifications

Clear all

alan.h7

Groupe: Enregistré

A(ont) rejoint: 2017/10/06

Active Member

	Yes definitely connected , very frustrating. Dans le forum Others (Archive)	il y a 8 years
	I'm using slic3r and stock settings for pla at .15mm . Dans le forum Others (Archive)	il y a 8 years
	outer perimeter walls on inside and outside not fused on cyc... Dans le forum Others (Archive)	il y a 8 years
	I have hardened rods, but my x and y have become scored due ... Dans le forum Hardware, firmware and software help	il y a 8 years
	ive just updated firmware and in the first print it has had ... Dans le forum Others (Archive)	il y a 8 years
	Got my tracking yesterday, and it shipped today. It’s a gre... Dans le forum General discussion, announcements and releases	il y a 8 years
	I got my tracking today!! Order was placed on 10/5/2017 so i... Dans le forum General discussion, announcements and releases	il y a 8 years
	Mine also changed to order being packed, very exciting, how ... Dans le forum General discussion, announcements and releases	il y a 8 years
	I emailed support this morning asking if I could get informa... Dans le forum General discussion, announcements and releases	il y a 8 years

Statistiques du forum

595 Forums

68.9 K Sujets

481.7 K Messages

15 En-ligne

77.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé