Avisos
Vaciar todo
ajsmcs
Grupo: Registrado
Registrado: 2018/04/24
Active Member
1
| Out of curiosity, why? | hace 6 years | |
| There is already a thermistor table within the stock prusa f... | hace 6 years | |
| UPDATE: I dug through the code again, and it turns out that... | hace 6 years | |
| Just to clarify - the only thing you did was wire directly t... | hace 6 years | |
|
I'm in the the exact same boat as you. I'm partway through ... En el foro Hardware, firmware and software help |
hace 7 years | |
|
FIXED. I updated to the new firmware, and that apparently f... En el foro Hardware, firmware and software help |
hace 7 years | |
|
XYZ Calibration Fails at 3rd Cal Point En el foro Hardware, firmware and software help |
hace 7 years |