AJS – Activité – Prusa3D Forum

Notifications

Clear all

AJS

Groupe: Enregistré

A(ont) rejoint: 2017/01/10

Noble Member

	You really need to look while you wiggle it, and see what it... Dans le forum Others (Archive)	il y a 8 years
	Or MeshMixer or meshlab Dans le forum Print tips (Archive)	il y a 8 years
	So the Benchy's show the printer handles overhangs just fine... Dans le forum Print tips (Archive)	il y a 8 years
	You may want to add your experience to this thread which dis... Dans le forum Others (Archive)	il y a 8 years
	Since this thread has been made more general that the origin... Dans le forum Software (Archive)	il y a 8 years
	As Joan said, heat block is the most likely. The only other... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	This happened to me also. The issue was that I had connect... Dans le forum Others (Archive)	il y a 8 years
	You should be able to do MUCH better than those photos by ad... Dans le forum Others (Archive)	il y a 8 years
	It would be good to understand if it is a hardware issue or ... Dans le forum Others (Archive)	il y a 8 years
	You need to let the XYZ calibration finish, and you need to ... Dans le forum Others (Archive)	il y a 8 years
	If you tell Slic3r to only support from the build plate, it ... Dans le forum Print tips (Archive)	il y a 8 years
	Re: MK2S and glass on heatbed Dans le forum Others (Archive)	il y a 8 years
	I feel your frustration. My MK2 was running nearly continu... Dans le forum Others (Archive)	il y a 8 years
	So, I had the original MK2. I printed and upgraded to the ... Dans le forum Improvements (Archive)	il y a 8 years
	Peter, Thank you so much for the time and explanation. It ... Dans le forum Others (Archive)	il y a 8 years
	A few things. 1) It would be good to go through a full X... Dans le forum Others (Archive)	il y a 8 years
	I currently have my MMU sprawling across a table from when I... Dans le forum Others (Archive)	il y a 8 years
	My MMU is still new (and working great), so I have not yet e... Dans le forum Others (Archive)	il y a 8 years
	Yeah, I was not looking closely (I have my own projects to w... Dans le forum Print tips (Archive)	il y a 8 years
	My MMU is still new (and working great), so I have not yet e... Dans le forum Others (Archive)	il y a 8 years

Page 25 / 51 Précédent Suivant

Statistiques du forum

585 Forums

68.3 K Sujets

478.3 K Messages

13 En-ligne

76.1 K Membres

Le dernier des messages: Adding Printers Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé