Notifications
Clear all
adiamant
Skupina: Registrovaný
Přidal se: 2019/08/12
Active Member
1
| Thanks a lot! | před 6 years | |
| Thank you very much Tim. Being a newbie it helps a lot havin... | před 6 years | |
| Thanks a lot! I’ll give it a go. Cheers | před 6 years | |
| Unfortunately the problems show after an hour, and more so i... | před 6 years | |
| Thanks a lot for your replies! Drive pulleys were not loose.... | před 6 years | |
| When doing the First Layer Calibration from the Calibration ... | před 6 years | |
| I have checked the belt tightness but the criteria is a bit ... | před 6 years | |
| Thanks a lot for your reply, when doing the first layer cali... | před 6 years | |
| New Member, new to 3D printing, first Benchy | před 6 years |