Aktivität
 
Benachrichtigungen
Alles löschen
aake.e
aake.e
Gruppe: Registriert
Beigetreten: 2017/12/18
Eminent Member
2
This problem is comming back to me on a regular basis and wh...

Im Forum Hardware, firmware and software help

Vor 4 years
A lot of problems. First year, Mk3 was good. Second with MMU...

Im Forum Hardware, firmware and software help

Vor 5 years
I have recurring problems with the MMU2S. It may work for a ...

Im Forum Hardware, firmware and software help

Vor 5 years
It suddenly started working again, I dont know why. "Loading...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
So its happening again, MMU2(s) is dojng strange things, loo...

Im Forum Assembly and first prints troubleshooting

Vor 5 years
Update: Did a couple of prints, no problem now. It must have...

Im Forum Assembly and first prints troubleshooting

Vor 6 years
I think I found the problem. ( No octoprint installed) The...

Im Forum Assembly and first prints troubleshooting

Vor 6 years
I did check all the cables before, did it again. Still not w...

Im Forum Assembly and first prints troubleshooting

Vor 6 years
MMU2S dont seem to be able to load filament at all (MMU2S do...

Im Forum Assembly and first prints troubleshooting

Vor 6 years
Filament legnth calib. valid after firmware upgrade?

Im Forum Hardware, firmware and software help

Vor 6 years
I could go for a long session of calibrating but that seemed...

Im Forum General discussion, announcements and releases

Vor 6 years
There seems to be too much occasional issues. Only managed t...

Im Forum Hardware, firmware and software help

Vor 6 years
Firmware problem ? ( MMU loads wrong filament)

Im Forum Hardware, firmware and software help

Vor 6 years
Thanx joey.c2 ! I think I got qiuet big difference in gear ...

Im Forum General discussion, announcements and releases

Vor 6 years
Thank you PJR for the reply, and a very good help in your li...

Im Forum Assembly and first prints troubleshooting

Vor 6 years
Printer head jams filament after upgrade(MMU2.0)

Im Forum Assembly and first prints troubleshooting

Vor 6 years
It worked at last, umpteen attempts.

Im Forum Hardware, firmware and software help

Vor 6 years
Prusa MMU firmware no D/L and corrupt by windows

Im Forum Hardware, firmware and software help

Vor 6 years
Forgot to write that the IKEA Lack table legs are hollow. I ...

Im Forum General discussion, announcements and releases

Vor 6 years
According to this thread 15-20 cm additional height will be...

Im Forum General discussion, announcements and releases

Vor 6 years
Seite 2 / 3
Teilen: