Activity
 
Notifications
Clear all
jmone
jmone
Group: Registered
Joined: 2018/11/23
Reputable Member
5
Here it is again 3DBenchy_ePA-CF

In forum PrusaSlicer

4 months ago
Hi Clemens, Yes that was done be me, from printing to making...

In forum General software discussion

9 months ago
I just add supports and the knock out pretty cleanly.

In forum PrusaSlicer

9 months ago
Yup it works. Cast the 2D Cookie Stamp deign from the above...

In forum General software discussion

9 months ago
FYI - this looks promising just importing an image into MS 3...

In forum General software discussion

9 months ago
Thanks - this is what I feared.... and I'm not sure it will ...

In forum General software discussion

9 months ago
Sorry for the late replay, I missed you post! I have a rang...

In forum PrusaSlicer

9 months ago
Software to Extrude Down a 2D image with a Draft?

In forum General software discussion

9 months ago
No problems, it's all about the community helping each other...

In forum PrusaSlicer

11 months ago
The model printed well (I did not use supports, brims etc) a...

In forum PrusaSlicer

11 months ago
I've got your sample and I'm currently printing the Right Ca...

In forum PrusaSlicer

11 months ago
...actually, I'm not sure this will help as I had a look at ...

In forum PrusaSlicer

11 months ago
...if you post the STL, I'll print it on my setup and if it ...

In forum PrusaSlicer

11 months ago
Are the skipped layers always in the same place or is it ran...

In forum PrusaSlicer

11 months ago
I ran a multi month experiment (the thread is somewhere on t...

In forum PrusaSlicer

11 months ago
Doubt it. It really is very easy to print when fully dry. ...

In forum PrusaSlicer

11 months ago
I've printed many spools of ePA-CF (all eSun) and all I can ...

In forum PrusaSlicer

11 months ago
I'm not familiar with this brand of PA-CF but 8h in a Food D...

In forum PrusaSlicer

11 months ago
Sounds good

In forum PrusaSlicer

1 year ago
Good you have the dimensions down and working. I find that w...

In forum PrusaSlicer

1 year ago
Page 1 / 17
Share: