Notifications
Clear all
Neophyl
Neophyl
Group: Registered
Joined: 2018/10/23
Famed Member
Gcode instructions are the only thing that matters. When yo...

In forum General discussion, announcements and releases

10 hours ago
Well you could start with the obvious and change the bridgin...

In forum PrusaSlicer

2 days ago
Thats more like it. This is the new arachne slicing engine ...

In forum PrusaSlicer

2 days ago
You do realise that glow in the dark filament is one of the ...

In forum How do I print this? (Printing help)

2 days ago
damn ran out of edit time. With arachne its mostly doing th...

In forum PrusaSlicer

2 days ago
I did print another one with the only change being to classi...

In forum PrusaSlicer

2 days ago
When I slice your project as is with 2.5.0 I dont get those ...

In forum PrusaSlicer

2 days ago
Check your motor pulley grub screws are on the flat and tigh...

In forum Assembly and first prints troubleshooting

2 days ago
Out of curiosity I printed your project. I didn't have a 0....

In forum PrusaSlicer

2 days ago
The bottom of your print indicates that it warped upwards an...

In forum Assembly and first prints troubleshooting

2 days ago
Yeah the mk3 wiring is a pain to work with. Which is why wh...

In forum Hardware, firmware and software help

3 days ago
That’s one of the most tight areas and your screw heads are ...

In forum Hardware, firmware and software help

3 days ago
Temperature depends on the printer, the nozzle type used as ...

In forum PrusaSlicer

3 days ago
Yes and Yes. Generally but theres always specifics involved...

In forum How do I print this? (Printing help)

3 days ago
Heat gun is the best, or a butane lighter with a blue flame ...

In forum Hardware, firmware and software help

4 days ago
No attached project. You did remember to zip it up before a...

In forum PrusaSlicer

4 days ago
Please help us to help you. Posting big long lists of setti...

In forum PrusaSlicer

4 days ago
Switch to snug support instead of grid. Also use the option ...

In forum PrusaSlicer

4 days ago
That slope probably doesn't need supports at all. I'd bet i...

In forum How do I print this? (Printing help)

4 days ago
try searching for "buldge" and yes that spelling while inco...

In forum How do I print this? (Printing help)

4 days ago
Page 1 / 214
Share: