Activity
 
Notifications
Clear all
John
John
Group: Registered
Joined: 2018/08/20
Reputable Member
5
I think the filament is very dry as a result of manufacture ...

In forum General discussion, announcements and releases

2 weeks ago
The satin sheet works good with tpu

In forum General discussion, announcements and releases

2 weeks ago
Burn this email - immediately

In forum General discussion, announcements and releases

1 month ago
Thanks I was coming to that conclusion myself

In forum How do I print this? (Printing help)

1 month ago
Thanks I thought with the higher temps for Flex is might sit...

In forum How do I print this? (Printing help)

1 month ago
Add few layers of TPU on top of PLA print

In forum How do I print this? (Printing help)

1 month ago
I too have noticed the default extrusion width for the profi...

In forum General discussion, announcements and releases

5 months ago
Did you mean these. Socket head cap screws.

In forum General discussion, announcements and releases

5 months ago
I’ve been using pccf with 0.6 nozzle and haven’t noticed thi...

In forum General discussion, announcements and releases

5 months ago
In theory a high temp could give better bonding to the previ...

In forum How do I print this? (Printing help)

6 months ago
Yes small holes are annoying especially anything smaller tha...

In forum How do I print this? (Printing help)

6 months ago
You should get your print to match the needed makita dimensi...

In forum How do I print this? (Printing help)

6 months ago
How did it break? parallel to the layer interface or across ...

In forum General discussion, announcements and releases

7 months ago
I support the idea of the 0.6mm nozzle as it will be stronge...

In forum PrusaSlicer

7 months ago
look in the perimeter settings and you can see a dimension f...

In forum PrusaSlicer

7 months ago
Has anyone seen comparison tests between the two?

In forum General discussion, announcements and releases

7 months ago
In regard to the shower rose I didn’t download load the file...

In forum How do I print this? (Printing help)

7 months ago
Yes you can just makes the number of layers for the top and ...

In forum How do I print this? (Printing help)

7 months ago
Happened once to me too

In forum Hardware, firmware and software help

7 months ago
No problems with PC and Flex. You have reset your live z va...

In forum General discussion, announcements and releases

8 months ago
Page 1 / 16
Share: