Activity
 
Notifications
Clear all
KLAUS
KLAUS
Group: Registered
Joined: 2018/08/09
Eminent Member
2
So then their is some built in code that does mesh repair on...

In forum PrusaSlicer

2 years ago
Here are some images:

In forum PrusaSlicer

2 years ago
Auto repair mesh upon import or Fix through Netfabb, Whats t...

In forum PrusaSlicer

2 years ago
Thanks Tim

In forum PrusaSlicer

2 years ago
So a correction on my part. apparently export plate as stl i...

In forum PrusaSlicer

2 years ago
"Load the repaired .obj into PSlicer, export the object as a...

In forum PrusaSlicer

2 years ago
Bobstro, I am not sure I understand this "The repair option ...

In forum PrusaSlicer

2 years ago
I tried using Export / plate as STL , but I found that it ...

In forum PrusaSlicer

2 years ago
Is there any way I can export a repaired mesh file of a mode...

In forum PrusaSlicer

2 years ago
Using water in the CW1 with water soluble resin

In forum Hardware, firmware and software help

2 years ago
@gnat Hi Gnat, thanks for that reply about the water washabl...

In forum Hardware, firmware and software help

2 years ago
How hard would it be to set the SL1 to use ELEGOO Water Wash...

In forum Hardware, firmware and software help

2 years ago
Thanks Karl

In forum PrusaSlicer

2 years ago
Do you know if Prusa has an email address to their tech supp...

In forum PrusaSlicer

2 years ago
I don't get it what would the prusa chat on the prusa eshop ...

In forum PrusaSlicer

2 years ago
Thanks for the reply Karl, I really would not know if I hav...

In forum PrusaSlicer

2 years ago
Is there any way to fix the layer height numbers from not be...

In forum PrusaSlicer

2 years ago
Thank you Karl very helpful!

In forum Hardware, firmware and software help

2 years ago
I would have ordered from them but then only ship to EU. If ...

In forum Hardware, firmware and software help

2 years ago
Is either of these noctura fans the same as the OEM part on ...

In forum Hardware, firmware and software help

2 years ago
Page 1 / 2
Share: