Aktywność
 
Notifications
Clear all
Xulkal
Xulkal
Grupa: Zarejestrowany
Dołączył: 2018/07/22
Trusted Member
3
Nice, I wasn't aware there was an SL1S model yet. Been a bit...

In forum Assembly and first prints troubleshooting

1 year temu
Day 11: after 20 something 3-5h prints, I have finally drain...

In forum Assembly and first prints troubleshooting

2 years temu
@mikeh-3 100 mm ID, 1 mm wide (102 mm OD)

In forum Assembly and first prints troubleshooting

2 years temu
wtf, when did my name get changed? I don't remember doing th...

In forum Assembly and first prints troubleshooting

2 years temu
Day 7 of 24x7 resin in the tank...still printing strong, sti...

In forum Assembly and first prints troubleshooting

2 years temu
@gnat Condensation from fumes? (grasping here hehe)

In forum Assembly and first prints troubleshooting

2 years temu
@gnat Resin in the screw holes finally working it's way out?

In forum Assembly and first prints troubleshooting

2 years temu
I sent all my feedback into support and linked to this threa...

In forum Assembly and first prints troubleshooting

2 years temu
@gnat This will be day 3 of continual printing, have to make...

In forum Assembly and first prints troubleshooting

2 years temu
@gnat That's just down right a sad. No, it's not normal to h...

In forum Assembly and first prints troubleshooting

2 years temu
Final thoughts, when I was reinstalling the FEPs on both tan...

In forum Assembly and first prints troubleshooting

2 years temu
100 mm ID, 1 mm wide (102 mm OD)

In forum Assembly and first prints troubleshooting

2 years temu
20h+ on the o-ring test with no leaks or indication of leaki...

In forum Assembly and first prints troubleshooting

2 years temu
@vintagepc The o-rings I linked are Buna-N which is decent f...

In forum Assembly and first prints troubleshooting

2 years temu
@gnat On that photo, the arrow is pointing to the FEP film t...

In forum Assembly and first prints troubleshooting

2 years temu
@gnat Na, the o-ring test is still going strong. No leaks ev...

In forum Assembly and first prints troubleshooting

2 years temu
16H mark (I woke up early) and it appeared that a slow leak ...

In forum Assembly and first prints troubleshooting

2 years temu
Yup, put it on the printer to ensure it doesn't cause a prob...

In forum Assembly and first prints troubleshooting

2 years temu
@gnat Per Prusa's own Siraya Tech Fast Black profile, a 150m...

In forum Assembly and first prints troubleshooting

2 years temu
Package arrived with new factory installed tank & FEP. S...

In forum Assembly and first prints troubleshooting

2 years temu
Strona 1 / 3
Share: