Activité
 
Notifications
Clear all
mavu
mavu
Groupe: Enregistré
A(ont) rejoint: 2016/10/17
Estimable Member
4
magnets in extruder upgrade bag, and other questions

Dans le forum General discussion, announcements and releases

il y a 3 years
UPDATE: List of all parts needed to upgrade to MK3S/MK2.5S/M...

Dans le forum General discussion, announcements and releases

il y a 3 years
UPDATE: List of all parts needed to upgrade to MK3S/MK2.5S/M...

Dans le forum General discussion, announcements and releases

il y a 3 years
How is it possible to say Slicer PE that he should change th...

Dans le forum How do I print this? (Printing help)

il y a 4 years
Yes, won't work, BUT if I remember correctly, you can set th...

Dans le forum Hardware, firmware and software help

il y a 5 years
I have a MK2 with MMU upgraded to MK2s. Currently the print...

Dans le forum General discussion, announcements and releases

il y a 5 years
*** UNTRIED ADVICE FOLLOWS - I HAVE NOT TRIED THIS *** The ...

Dans le forum Others (Archive)

il y a 5 years
The PEI bed needs to be cleaned regularly with acetone. Try ...

Dans le forum Others (Archive)

il y a 5 years
I’ve spent a lot of time meticulously cleaning the bed, and ...

Dans le forum Others (Archive)

il y a 5 years
Can someone PLEASE explain to me how to use the ColorPrint u...

Dans le forum Others (Archive)

il y a 5 years
Yes, i have the latest installed. I don't have jams, clogs, ...

Dans le forum Others (Archive)

il y a 5 years
lots of Extruder clicking with slic3r 1.38.3 and latest firm...

Dans le forum Others (Archive)

il y a 5 years
I tried this as I though it would work as described. Unfortu...

Dans le forum Others (Archive)

il y a 5 years
It is most likely a result of having bowden tubes. I have ob...

Dans le forum Others (Archive)

il y a 5 years
Update: The ends of the filament looked like then when I to...

Dans le forum Others (Archive)

il y a 5 years
The retract value is to relieve the pressure built up in the...

Dans le forum Others (Archive)

il y a 5 years
Thanks for the info on using cut with Slic3r, I can perform ...

Dans le forum Others (Archive)

il y a 5 years
I doubt it means "any and all" flexible filaments. Some peo...

Dans le forum Others (Archive)

il y a 5 years
Yes, this bugs me as well. As far as I can tell, the colorp...

Dans le forum Others (Archive)

il y a 5 years
Is there someone who can help? I am not sure if I understoo...

Dans le forum Others (Archive)

il y a 5 years
Page 1 / 9
Partager :