Activity
 
Notifications
Clear all
Steve
Steve
Group: Registered
Joined: 2016/09/29
Estimable Member
4
Even if there wasn't, there are ethernet-to-wifi adapters, s...

In forum General discussion, announcements and releases

6 months ago
Thank you very much for the reply. I will most certainly pas...

In forum Coronavirus (COVID-19)

2 years ago
@nilok Pretty sure @howardc's question about hist 3d printed...

In forum Coronavirus (COVID-19)

2 years ago
Has my thread been erroneously merged with some other one? A...

In forum Coronavirus (COVID-19)

2 years ago
Yes that is my opinion as well, but its a matter of liabilit...

In forum Coronavirus (COVID-19)

2 years ago
The community edition (and myself and some other people I kn...

In forum Coronavirus (COVID-19)

2 years ago
Given the urgency with which they're needed - if they are de...

In forum Coronavirus (COVID-19)

2 years ago
Disinfecting / Re-disinfecting the masks? (Belgium refusing ...

In forum Coronavirus (COVID-19)

2 years ago
I know, you can also split them by using the "Set as separat...

In forum PrusaSlicer

3 years ago
I really like the new PrusaSlicer. The graphics, the arrang...

In forum PrusaSlicer

3 years ago
I still don't like working with this new model site for a fe...

In forum General discussion, announcements and releases

3 years ago
I also find myself visiting once every week or even 2 instea...

In forum General discussion, announcements and releases

3 years ago
I get where you're coming from, but being a web-developer my...

In forum General discussion, announcements and releases

3 years ago
Yeah... ++++ from me too. I've seen a bunch of prints I like...

In forum General discussion, announcements and releases

3 years ago
I've tried using the Pi0W via the GPIO and it's massively un...

In forum General discussion, announcements and releases

3 years ago
It's what I was thinking. I just wonder if you can still use...

In forum General discussion, announcements and releases

3 years ago
How the nozzle "finds" the bed to print on is based on 2 thi...

In forum Assembly and first prints troubleshooting

3 years ago
It's this model from thingiverse, but I have remixed it so I...

In forum Hardware, firmware and software help

3 years ago
That's an interesting concept but I don't see how that is th...

In forum General discussion, announcements and releases

3 years ago
That comment is from me. It's far too fragile when I print ...

In forum General discussion, announcements and releases

3 years ago
Page 1 / 7
Share: