Notifications
Clear all
simon.m
simon.m
Group: Registered
Joined: 2016/09/07
Trusted Member
3
Still nothing here. So much for "Late November - Early Dece...

In forum General discussion, announcements and releases

4 years ago
Wouldn't you have thought that they'd have experienced this ...

In forum General discussion, announcements and releases

4 years ago
Just had a conversation with Chat. Apparently the latest vo...

In forum General discussion, announcements and releases

4 years ago
I still haven't had the option of getting mine from my order...

In forum General discussion, announcements and releases

4 years ago
And what a waste of time that turned out to be. Still an un...

In forum General discussion, announcements and releases

4 years ago
I spoke to Prusa support a couple of weeks ago and they said...

In forum General discussion, announcements and releases

4 years ago
They will print fine, they’re just not ‘tuned’ specifically ...

In forum Others (Archive)

4 years ago
The link is in the first post. This is what I printed to ...

In forum Others (Archive)

4 years ago
Are you saying the 16T idler is smaller than the smooth one ...

In forum Others (Archive)

4 years ago
I can happily say that with the smaller diameter 16 tooth id...

In forum Others (Archive)

4 years ago
With the bearings on the toothed idler being flush with the ...

In forum Others (Archive)

4 years ago
Sorry, I did have a quick scan through but I missed the pos...

In forum General discussion, announcements and releases

4 years ago
I'm still trying print without OctoPi, but shifted layers ar...

In forum General discussion, announcements and releases

4 years ago
Makes sense to heat the bed first and nozzle second. That w...

In forum Hardware, firmware and software help

4 years ago
I'd guess that it's because it serves no purpose at that poi...

In forum Others (Archive)

4 years ago
I wouldn't expect a Mk3 specific slicing of it. The gcode s...

In forum Others (Archive)

4 years ago
Head to here You should have a link to Live Chat at the bo...

In forum Others (Archive)

4 years ago
I also did the factory reset and fresh calibration prior to ...

In forum General discussion, announcements and releases

4 years ago
Sometimes I heard very hard step from motors. Without conseq...

In forum General discussion, announcements and releases

4 years ago
Have you got it running in 'Stealth' mode ? If mine is in S...

In forum Others (Archive)

4 years ago
Page 1 / 3
Share: