Notifications
Clear all
thomas.s38
thomas.s38
Group: Registered
Joined: 2017/12/11
Active Member
1
Top solid infill instead of perimeter

In forum How do I print this? (Printing help)

4 years ago
Is there any reason why the PE of Slicer don´t support Adapt...

In forum General discussion, announcements and releases

4 years ago
Thanks a lot 🙂 Got a better understanding what i have to t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Settings for printing with 0.6 nozzle

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
So i got it 😀 Was my own fault. The belt was too tight. ...

In forum Assembly and first prints troubleshooting

4 years ago
Is it some kind of Layer Shift?

In forum Assembly and first prints troubleshooting

4 years ago
So today i tried with new firmware and 1.40 Version of slic3...

In forum How do I print this? (Printing help)

4 years ago
Hello! Are there any new Information on this issue? Did you...

In forum How do I print this? (Printing help)

4 years ago
Did not make any prints the last few days. Think my next ste...

In forum How do I print this? (Printing help)

4 years ago
Thanks for the hint with retraction speed. But for the momen...

In forum How do I print this? (Printing help)

4 years ago
I´m using default settings from Prusa PET for cooling. Keef ...

In forum How do I print this? (Printing help)

4 years ago
For the moment it feels quite disappointing for me. I tried ...

In forum How do I print this? (Printing help)

4 years ago
Thanks for your help. So i changed Settings to the following...

In forum How do I print this? (Printing help)

4 years ago
Problem with stringing on Black PETG

In forum How do I print this? (Printing help)

4 years ago
Share: