|
Is there a page where I can have a look on the supported [xx... In forum General discussion, announcements and releases |
5 years ago |
|
Good Morning, asked for help inside the Cura Forum, got a in... In forum General discussion, announcements and releases |
5 years ago |
|
Good morning neo, just tried it. Unlikely the same behavior,... In forum General discussion, announcements and releases |
5 years ago |
|
deleted, I generated a G-Code to move the hotend to center..... In forum General discussion, announcements and releases |
5 years ago |
|
Attached. THX
Attachment removed In forum General discussion, announcements and releases |
5 years ago |
|
Comparing the G-code files, why did I not think of that ....... In forum General discussion, announcements and releases |
5 years ago |
|
Still improving my knowledge, this is my first printer so pl... In forum General discussion, announcements and releases |
5 years ago |
|
Hi neophyl, thx for your info!! just had the time to test. s... In forum General discussion, announcements and releases |
5 years ago |
|
Hi Possible to change or no go? In forum General discussion, announcements and releases |
5 years ago |
|
OK, sorry but I do not know how to insert my videos with the... In forum General discussion, announcements and releases |
5 years ago |
|
@sembazuru Sorry for my worse english, do not really get the... In forum General discussion, announcements and releases |
5 years ago |
|
I do not understand your post, what I want to have is standi... In forum General discussion, announcements and releases |
5 years ago |
|
Hi neophyl thx for help !! I am not realy familiar with the ... In forum General discussion, announcements and releases |
5 years ago |
|
Start Code is betweent Hotend heatup. So this is the wrong p... In forum General discussion, announcements and releases |
5 years ago |
|
This should be the way, like Ulti original In forum General discussion, announcements and releases |
5 years ago |
|
Prusa Slicer on Ultimaker - first layer problem In forum General discussion, announcements and releases |
5 years ago |
