Notifications
Clear all
jphalip
jphalip
Group: Registered
Joined: 2021/10/19
Active Member
1
One more update. I managed to close those little gaps by bum...

In forum General discussion, announcements and releases

11 hours ago
So I've now tried with a larger, more practical print (see a...

In forum General discussion, announcements and releases

14 hours ago
@R&D: I noticed the same issue in both Prusa Slicer 2.4 ...

In forum General discussion, announcements and releases

1 day ago
Thank you all again for the tips. I actually didn't know tha...

In forum General discussion, announcements and releases

2 days ago
Ok sorry for the noise. The blockage was in fact caused by a...

In forum General discussion, announcements and releases

3 days ago
Hi all. Thanks for the answers and ideas! One thing first: T...

In forum General discussion, announcements and releases

3 days ago
One more thing I forgot to mention, I'm printing with the "0...

In forum General discussion, announcements and releases

3 days ago
So I've redone a full wizzard calibration but the issue is s...

In forum General discussion, announcements and releases

3 days ago
Hi all, I've attached the project file. I have a Prusa MK3...

In forum General discussion, announcements and releases

4 days ago
Thanks for the tips. I will try to play with the extrusion m...

In forum General discussion, announcements and releases

4 days ago
How to avoid these marks on the top of my prints?

In forum General discussion, announcements and releases

4 days ago
Oh that's very neat, thanks for the tip. Regarding the off-p...

In forum PrusaSlicer

5 days ago
Oh that's a good workaround, thanks!

In forum PrusaSlicer

5 days ago
Exporting/applying a subset of print settings

In forum PrusaSlicer

6 days ago
Also, by chance are you aware of an existing STL/model for a...

In forum General discussion, announcements and releases

1 month ago
That makes sense, thanks for your reply. Just one thing: how...

In forum General discussion, announcements and releases

1 month ago
Prusa Slicer profile for using volcano nozzle?

In forum General discussion, announcements and releases

1 month ago
Thanks for your reply. So here I assume one must set a speci...

In forum General discussion, announcements and releases

11 months ago
Gcode to move extruder to the back of the bed

In forum General discussion, announcements and releases

11 months ago
Share: