Notifications
Clear all
SailorEric
SailorEric
Group: Registered
Joined: 2021/09/25
Trusted Member
3
Einsy board replacement

In forum Hardware, firmware and software help

2 days ago
Im at three printers and have plans.....two Mk3S+ and a Rais...

In forum General discussion, announcements and releases

1 week ago
I've had very good results with Atomic but just started havi...

In forum General discussion, announcements and releases

3 weeks ago
Printed containers that fit in the spool centers. In my drip...

In forum General discussion, announcements and releases

2 months ago
Ah and I'll add one other thing. Yes, there are a lot of des...

In forum Awesome prints (Hall Of Fame)

2 months ago
These are body powered. The hand model uses wrist movement t...

In forum Awesome prints (Hall Of Fame)

2 months ago
If you're going to print PETG on the smooth plate you should...

In forum Hardware, firmware and software help

2 months ago
Fulfilling dreams

In forum Awesome prints (Hall Of Fame)

3 months ago
ASA is hydroscopic so it might need to be dried. It also doe...

In forum General discussion, announcements and releases

3 months ago
So I know you said you're using the preset for Prusament ASA...

In forum General discussion, announcements and releases

3 months ago
Just ran a test roll of 100% recycled PETG from GreenGate 3D...

In forum General discussion, announcements and releases

3 months ago
Not sure as I'm not in a place that I have much access to Sa...

In forum General discussion, announcements and releases

3 months ago
I print in an area where the humidity isn't going to get muc...

In forum General discussion, announcements and releases

3 months ago
See how it goes for others!!! I'm really buried in work righ...

In forum PrusaSlicer

3 months ago
One day when I have time I'm going to figure out github. Rig...

In forum How do I print this? (Printing help)

3 months ago
Afraid not, went back to tried and true. Very, very bust rig...

In forum PrusaSlicer

3 months ago
The preview looked good. I was afraid I had something seriou...

In forum PrusaSlicer

3 months ago
The preview looked great, no banding. Thought my trusty prin...

In forum How do I print this? (Printing help)

3 months ago
Just had an issue with the beta version. several models prin...

In forum PrusaSlicer

3 months ago
Checked everything else then my brain remembered I had slice...

In forum How do I print this? (Printing help)

3 months ago
Page 1 / 4
Share: