3Delight – Aktywność – Prusa3D Forum

Notifications

Clear all

3Delight

Grupa: Moderator

Dołączył: 2015/09/25

Tytuł: Moderator Moderator

	OK, all fixed(ish) now. I picked out what PLA that I could ... In forum Prusa i3 kit (Archive)	11 years temu
	I will try to clean the Heat Break threads and screw it back... In forum Hardware, firmware and software help	11 years temu
	I didn't skip any part of the assembly instructions. Everyt... In forum Prusa i3 kit (Archive)	11 years temu
	Is it possible to do a straight swap for a V6? IE, without ... In forum Prusa i3 kit (Archive)	11 years temu
	Thanks for the update roman.t. I wondered if that might hav... In forum Prusa i3 kit (Archive)	11 years temu
	Wrong Hot-End supplied in kit? In forum Prusa i3 kit (Archive)	11 years temu
	Until I can take a couple of photos of my Hot End here are a... In forum Hardware, firmware and software help	11 years temu
	OK, I disassembled the extruder enough to get the Hot End ou... In forum Hardware, firmware and software help	11 years temu
	I'm also having this problem with my new kit, and it does se... In forum Hardware, firmware and software help	11 years temu
	OK, so I managed to get a new fuse and the printer is now wo... In forum Prusa i3 kit (Archive)	11 years temu
	1st Time Builder - no motor movement at all... In forum Prusa i3 kit (Archive)	11 years temu

Strona 42 / 42 Wstecz

Statystyki Forum

598 Fora

71.8 K Tematy

503.9 K Posty

12 Online

83.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte