Avisos
Vaciar todo
3Delight
Grupo: Moderador
Registrado: 2015/09/25
Título: Moderador Moderator
2
|
I didn't skip any part of the assembly instructions. Everyt... En el foro Prusa i3 kit (Archive) |
hace 10 years | |
|
Is it possible to do a straight swap for a V6? IE, without ... En el foro Prusa i3 kit (Archive) |
hace 10 years | |
|
Thanks for the update roman.t. I wondered if that might hav... En el foro Prusa i3 kit (Archive) |
hace 10 years | |
|
Wrong Hot-End supplied in kit? En el foro Prusa i3 kit (Archive) |
hace 10 years | |
|
Until I can take a couple of photos of my Hot End here are a... En el foro Hardware, firmware and software help |
hace 10 years | |
|
OK, I disassembled the extruder enough to get the Hot End ou... En el foro Hardware, firmware and software help |
hace 10 years | |
|
I'm also having this problem with my new kit, and it does se... En el foro Hardware, firmware and software help |
hace 10 years | |
|
OK, so I managed to get a new fuse and the printer is now wo... En el foro Prusa i3 kit (Archive) |
hace 10 years | |
|
1st Time Builder - no motor movement at all... En el foro Prusa i3 kit (Archive) |
hace 10 years |
Página 42 / 42
Anterior