Notifications
Clear all
3Delight
Group: Moderator
Joined: 2015/09/25
Title: Moderator Moderator
2
|
I didn't skip any part of the assembly instructions. Everyt... In forum Prusa i3 kit (Archive) |
10 years ago | |
|
Is it possible to do a straight swap for a V6? IE, without ... In forum Prusa i3 kit (Archive) |
10 years ago | |
|
Thanks for the update roman.t. I wondered if that might hav... In forum Prusa i3 kit (Archive) |
10 years ago | |
|
Wrong Hot-End supplied in kit? In forum Prusa i3 kit (Archive) |
10 years ago | |
|
Until I can take a couple of photos of my Hot End here are a... In forum Hardware, firmware and software help |
10 years ago | |
|
OK, I disassembled the extruder enough to get the Hot End ou... In forum Hardware, firmware and software help |
10 years ago | |
|
I'm also having this problem with my new kit, and it does se... In forum Hardware, firmware and software help |
10 years ago | |
|
OK, so I managed to get a new fuse and the printer is now wo... In forum Prusa i3 kit (Archive) |
10 years ago | |
|
1st Time Builder - no motor movement at all... In forum Prusa i3 kit (Archive) |
10 years ago |
Page 42 / 42
Prev