3Delight – Activité – Prusa3D Forum

Notifications

Clear all

3Delight

Groupe: Modérateur

A(ont) rejoint: 2015/09/25

Titre: Modérateur Moderator

	Try raising the bed temperature for the first layer to 70°C,... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I don't know if this will help you at all: (see his SOLVE... Dans le forum Software (Archive)	il y a 9 years
	That's pretty much what Prusa have said Roger. I might try ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	OK codded up that last post! I keep getting confused whethe... Dans le forum Improvements (Archive)	il y a 9 years
	My first print with ColorFabb XT (240°/90°) on my MK2 result... Dans le forum Software (Archive)	il y a 9 years
	Then something is wrong with the printer. When carriage hits... Dans le forum Others (Archive)	il y a 9 years
	That's sad to hear Richard... maybe Josef can crack it then.... Dans le forum Improvements (Archive)	il y a 9 years
	I've never printed with nylon but have looked into it: Temps... Dans le forum Others (Archive)	il y a 9 years
	OK, sliced model using the default Prusa 0.200 and ColorFabb... Dans le forum Print tips (Archive)	il y a 9 years
	Alternatively (and more easily) just use menu item "Move axi... Dans le forum Others (Archive)	il y a 9 years
	Depends which way you are talking about it... a) When lookin... Dans le forum Others (Archive)	il y a 9 years
	I've just bought a spool of ColorFabb XT (black) to print a ... Dans le forum Print tips (Archive)	il y a 9 years
	Thanks for that Richard! Now this is interesting... But i... Dans le forum Improvements (Archive)	il y a 9 years
	I was just going by what the article says. I assumed that w... Dans le forum Improvements (Archive)	il y a 9 years
	Edit: you could use them for swapping filament drive pulleys... Dans le forum Improvements (Archive)	il y a 9 years
	I wonder if anyone has tried using RC Servo motors for the e... Dans le forum Improvements (Archive)	il y a 9 years
	Maybe if the mechanism is readily available... Would it add... Dans le forum Improvements (Archive)	il y a 9 years
	Non-Planar Layer FDM... Dans le forum Improvements (Archive)	il y a 9 years
	From what I understand Simplify3D, Cura and Slic3r can do it... Dans le forum Improvements (Archive)	il y a 9 years
	I think the Net would explode if this hypothetical printer c... Dans le forum Improvements (Archive)	il y a 9 years

Page 36 / 42 Précédent Suivant

Statistiques du forum

585 Forums

67.9 K Sujets

476 K Messages

13 En-ligne

75.5 K Membres

Le dernier des messages: What cause the filament to "coil" during printing? Notre nouveau membre: klong Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé