Aktivität
 
Benachrichtigungen
Alles löschen
kerry.c
kerry.c
Gruppe: Registriert
Beigetreten: 2017/09/29
Active Member
1
Guys, I think I have resolved the issue. I completely disas...

Im Forum Hardware, firmware and software help

Vor 2 years
@pcweber Can you shed some insight as to what causes the gea...

Im Forum Hardware, firmware and software help

Vor 2 years
Issue: Filament not getting through?

Im Forum Hardware, firmware and software help

Vor 2 years
...printing one piece at a time. The Simplify3D Factory fi...

Im Forum Others (Archive)

Vor 5 years
in here Reviewed that thread (and some external searching)...

Im Forum Others (Archive)

Vor 5 years
Page 9, PLA filament (or PETG, APLA, htPLA, PC-max....) not...

Im Forum Others (Archive)

Vor 5 years
230 for the Hot-end is way too much for PLA.... And the bed...

Im Forum Others (Archive)

Vor 5 years
have a look in this thread Simplify3D settings regards ...

Im Forum Others (Archive)

Vor 5 years
I think in Simplify3D in Under HELP/Configuration Assistant ...

Im Forum Others (Archive)

Vor 5 years
Okay, I have adjusted the settings as I think you're suggest...

Im Forum Others (Archive)

Vor 5 years
230 for the Hot-end is way too much for PLA.... And the bed...

Im Forum Others (Archive)

Vor 5 years
What temperature are you using on the Bed? The bed tempera...

Im Forum Others (Archive)

Vor 5 years
You can try to squish the first layer a little better by adj...

Im Forum Others (Archive)

Vor 5 years
What material are you printing in? Sorry, should have clar...

Im Forum Others (Archive)

Vor 5 years
Edges lifting – Cessna 152 Trainer

Im Forum Others (Archive)

Vor 5 years
Teilen: